The electric sprayer failure solution

Electric sprayer with advantages of small, flexible, easy to use and high efficiency, loved by more and more farmers and become the main tool of the spraying. However, due to the many farmers did not grasp the correct way to use the electric sprayer, there are some problems during power sprayer using. Today Zhengzhou Oriole Electronic (Group) Joint-Stock Co., Ltd. will tell you how to solve the electric sprayer failures.
1. The air and water leakage at the spraying handle switch. The switch washer wear or switch asbestos line wear can cause switch leakage phenomenon, it should be replaced by new washers or asbestos-line. And leak due to the leather washer damaged or gas chamber unsoldering and therefore proceed timely welding to ensure the electric sprayer normal use.
2. Gas chamber can not intake air and pressure does not focus on electric rocker. This is because the sprayer packing cup hardening or shrinkage, or the nut at the bottom of packing cup loosening. We should pressure cup slightly open or switch to the new cup, to immerse in the oil or lubricating oil, after lubricating expansion to install, coat with a little oil, and tighten the bottom of the nut.
3. Electric sprayer fog is bad, easy flow drops. This is because the nozzle clogging of sprayer, the filter is clogged or water ball valve is pluged up by dirt things. We should clear the spray holes, cleare debris; open the casing clean the filter if it blockage, check the ball valve to remove dirt.