Pay attention to the using of thermal fogger in greenhouses

Thermal fogger is a kind of pulse jet engine-powered cast smoke plant protection machinery. It casts smoke particles is small, with a multi-directional deposition characteristics favorable to crop leaf smoke particles in positive and negative direction and deposited on the various parasites, bacteria and insects increased with opportunities to engage in greenhouses such relatively closed space for pest control can get the desired effect.
To ensure proper use of thermal fogger and safe operation, The following will briefly describe thermal fogger in use in greenhouses precautions.
First, before the start:
1 An operator should be strictly in accordance with the rules for operation, the operation should wear protective supplies, drunk and sick deformed weak personnel shall induction operation.
2 Two indoor studio should be checked before the job if there is fire and flammable materials, if any, be sure to extinguish the fire or remove flammable items, to avoid fire.
3 Thermal fogger should be checked before starting drug valve in the closed state, if the valve is in the closed state drug should be placed in the closed state. Startup smoke machine horizontally on a flat, dry place. Smoke machine nozzle can not avoid facing the human body partial burns.
4 Should be checked before starting batteries are charged, without electricity, should be replaced. Replace the battery when the attention marked in accordance with the positive and negative electrode plates installed.
5 Thermal fogger motor fuel used must be pure gasoline. Oil or easy-sum game, so that the system does not work. Meanwhile gasoline dosage should not normally exceed the total capacity of the fuel tank 2/3 plus a good petrol, hand tighten petrol cap, do not use excessive force to avoid damage, resulting in poor sealing.
Second, during the operation:
1 Thermal fogger starts, turn off the power switch; engine preheating 1 ~ 2min before spray.
2 If the job smoke a sudden stop, they must immediately close the liquid valve, then loosen the drug cover, release the compressed air inside the medicine cabinet, so do not result in smoke mouth on fire, as well as difficulty in starting again.
3 Jobs that need filling, dosing should be carried out after shutdown. Drug delivery by first off switch, throttle switch off after the order. Must be shut down after 10min and then add gasoline or liquid, or prone to accidents.
4 Thermal fogger work, the combustion chamber and the outer shield temperature are high, keep your hands and clothes do not touch these parts to avoid scalding burns.
5 Thermal fogger work, should try to maintain the level of the body, if necessary tilted angle is generally not more than 60b.
Three, stop:
1 One must first shut off the liquid valve, until the smoke puffing mouth again when no longer turn off the engine, otherwise the medicine cabinet of the liquid will continue to flow into the combustion chamber, causing difficulty in starting the next, or cause spraying mouth fire.
2 When the thermal fogger stop using the drug should be promptly unscrew the cover and release the compressed gas tank, so as to avoid smoke mouth on fire, as well as difficulty in starting again.
3 If you will not use the thermal fogger for a long time ,you must pour the excess liquid, wash the residual liquid tank, air dry moisture, exterior cleaned on a flat, dry, cool, well-ventilated place to prepare for the next use.